Site icon Thunda Funda

Different types of cement testing to find the best cement

Most of the buildings or structures are made with the help of cement and other different building materials. Therefore it is important to check for the quality and strength of the best cement based on its usage on its durability and strength. There are various tests available that are used to check fineness, soundness, setting time, and strength. Here is some of the test that is followed to find the best cement based on its purposes.

Fineness test:

The rate of hydration, the evolution of heat, and strength is determining the fineness of the cement. A test called the sieve test is used to check the fineness test. It gives the report for the method, control of grinding and testing finished cement. It also determines the rate of passage of air through a bed of cement. It also checks for the rate of sedimentation of the cement in kerosene or by elutriation in an airstream.

Soundness:

A soundness test is done by undergoing any appreciable expansion that could disrupt a mortar or concrete. The property of soundness is tested by focusing on the set cement to boiling water or with high-pressure of steam. The result is found by raising the presence in the cement of too much free of magnesia or it is hard-burned free lime.

Setting time:

As everyone knows that the harder it is the stronger it gets. Thus setting time is a process where you will be able to find the time required for cement to get set with concrete or other materials. The first time is known as the time interval between the mixing of the cement with water and other materials such as plastics, stiffening, to a certain degree. The time required to set cement has acquired a sufficient firmness to resist a certain defined pressure. The final stage will have the timing up to the 4 minutes for the common or ordinary temperature and the setting time lasts more than 10 to 12 hours.

Strength:

The strength of the cement is determined by composing one part cement into three parts such as sand, by weight, mixed with a certain amount of water. Tensile is the test taken to determine the strength test of the cement and it is taken over the briquettes. The standard test requires a transverse test on a 1:3 ratio of cement and sand mortar prism. The test is followed by breaking up the prism into two halves that remain after bending. The minimum strength at 3 and 7 days results in the best. If it has been for 28 days it will go under rapid hardening. In real-time, the construction strength of the concrete is tested by compressive testing made on cylinders or cubes that are being placed from the concrete.

Bottom lines:

Therefore these are the mandatory tests to be involved in while choosing for best cement it is also checked by presences of lumps, float testing, and date of manufacturing. So do these mandatory tests to check the quality of cement you are going to buy for the construction.

Exit mobile version